Difference between revisions of "Remote server"
Line 2: | Line 2: | ||
I am not sure that you know what was in the '''[[rpi]]''' | I am not sure that you know what was in the '''[[rpi]]''' | ||
− | + | It had '''[[lamp]]''' installed | |
running a Private Cloud with the wiki. | running a Private Cloud with the wiki. | ||
Line 8: | Line 8: | ||
A turnkey system for $100 is a good deal. | A turnkey system for $100 is a good deal. | ||
− | You can get a pizero W for $ | + | You can get a pizero W for $20 plus tax and shipping. |
But then you need an SD card and power supply. | But then you need an SD card and power supply. |
Revision as of 16:40, 19 May 2024
I am not sure that you know what was in the rpi
It had lamp installed
running a Private Cloud with the wiki.
A turnkey system for $100 is a good deal.
You can get a pizero W for $20 plus tax and shipping.
But then you need an SD card and power supply.
Then download the software
and burn it to the SD card.
Then a lot of time to set it up.
If you would like another one then email Mr Pi
- Proof of Concept - remote server
SSH server running
Remote server will check the gateway address
Emails me the results
crontab -e
00 16 * * * ~/curl ipinfo.io/ip>>address_today.txt
/usr/sbin/sendmail jxx@xxxxxxx.com < ~/address_today.txt
_--------------------------
sudo nano /etc/sysctl.d/routed-ap.conf ?
sudo nano /etc/sysctl.conf ?
- Enable IPv4 routing
net.ipv4.ip_forward=1
sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
sudo netfilter-persistent save
- Filtering rules are saved to the directory /etc/iptables/
sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE
sudo sh -c "iptables-save > /etc/iptables.ipv4.nat"
sudo nano /etc/rc.local
- Add above “exit 0”:
iptables-restore < /etc/iptables.ipv4.nat
- run
- sudo systemctl unmask hostapd
- sudo systemctl enable hostapd
- sudo systemctl start hostapd
- sudo service dnsmasq start